Craftsman Toolbox free tools

Roof tile calculator

Enter the roof area or the eaves length and rafter length, choose the tile type and get the number of tiles, metres of battens and ridge tiles.

...

How it works

Roof area for one plane = eaves length x rafter length (measured along the slope, from eaves to ridge). A normal gable roof has two planes. Use the slope length, not the horizontal width of the house.

Tiles = area x tiles per m² from the manufacturer, plus 5 % for cutting at hips, valleys and verges. Typical values: Danish concrete tiles about 10 per m², clay pantiles about 14 and natural slate about 25 depending on size and lap.

Battens run horizontally at the tile gauge (the batten spacing): running metres = area / gauge plus 5 %. Ridge tiles = ridge length x tiles per metre, typically 2.5 to 3.3 per metre.

Results are estimates for planning. Check product data sheets, local building rules and an engineer's calculations where required.

Frequently asked questions

How many roof tiles per m²?

Concrete tiles about 9.5 to 10.5 per m², clay pantiles 13 to 15, small clay plain tiles up to 60, and slate 20 to 30 depending on size and lap. Always check the gauge for your roof pitch.

What is batten gauge?

The distance between battens, centre to centre, which decides how much each tile overlaps the one below. Low pitches need a smaller gauge and therefore more tiles and battens.

What do the tiles weigh?

Concrete tiles weigh about 40 to 45 kg/m², clay about 40 kg/m² and slate about 30 to 40 kg/m². Changing to a heavier tile may require a check of the rafters.

More tools in painting, tiles and floors

📐Room area calculatorMeasure each room once and get every area you need for a quote: floor, walls minus doors and windows, ceiling, skirting length and volume.🔲Tile calculatorEnter the area and the tile size, pick the laying pattern and get the number of tiles and boxes plus how much tile adhesive and grout to buy.🪵Flooring calculatorEnter the room size and the pack coverage printed on the box and get the number of packs, the underlay and the metres of skirting you need.🎨Paint calculatorEnter the room size or the wall area, the number of doors and windows and the coverage from the tin, and get the litres and tins you need.🧻Wallpaper calculatorEnter the total length of the walls, the room height, the roll size and the pattern repeat to see how many strips you get per roll and how many rolls to buy.📏Skirting board calculatorEnter the room perimeter, door openings and board length to get the number of skirting boards, the corner cuts and the nails or glue to fix them.🪣Self-levelling screed calculatorEnter the floor area and the average layer thickness, choose the product type and get the kilos and bags of self-levelling compound, the primer and the mixing water.🧴Sealant calculatorEnter the joint length, width and depth and see how much silicone or acrylic sealant you need and how many cartridges to buy.🧱Plaster and filler calculatorEnter the wall area and the thickness of the layer, choose plaster or filler and get the kilos and bags or buckets to buy.📐Mitre angle calculatorGet the mitre saw setting for frames and polygons, for skirting in any wall corner, and the compound mitre and bevel for crown moulding cut flat on the saw.🛢️Decking oil calculatorEnter the deck area, the number of coats and the coverage from the can and get the litres of decking oil and how many cans to buy.

All tools (64) →