Craftsman Toolbox free tools

Slope and fall calculator

Enter a slope in any format and a length, and get the slope in every other format plus the total height difference.

...

How it works

All formats come from the same number: rise per horizontal length. Percent = rise / run x 100, mm per metre = percent x 10, degrees = atan(rise / run), and the ratio 1 : x has x = run / rise.

Total fall = length x percent / 100. Slope length = square root of (length² + fall²).

Typical values: drain pipes and terraces 1 to 2 %, flat roofs at least 1 to 2 %, and wheelchair ramps no steeper than 1:12 (8.3 %). The Danish building regulations BR18 recommend ramps no steeper than 1:20 (5 %) on accessible routes.

Results are estimates for planning. Check product data sheets, local building rules and an engineer's calculations where required.

Frequently asked questions

How much fall does a drain pipe need?

Usually 1 to 2 % (10 to 20 mm per metre) for 110 mm pipes, and at least 2 % for smaller pipes. Too little fall causes blockages, too much lets water run away from solids.

What is 1:12 as a percentage?

1:12 is 8.33 % or 4.8 degrees. 1:20 is 5 % or 2.9 degrees, and 1:50 is 2 %.

How much fall should a terrace or patio have?

1.5 to 2 % away from the house is common, which is 15 to 20 mm per metre. Water runs off without the surface feeling sloped.

More tools in building and carpentry

🪚Cut list optimizerTell it the length you buy (for example 4.8 m boards) and the pieces you need.🧱Concrete calculatorEnter the size of your slab, footing or column and get the concrete volume, the number of premix bags and a mix list for site mixing.🪜Stair calculatorEnter the floor-to-floor height and the space you have, or choose the number of steps yourself, and get every stair measurement with a comfort check.🏠Roof pitch calculatorEnter the building width and either the roof rise or the angle, and get the pitch in every format, the rafter length and the roof area for ordering roofing.🪵Deck calculatorEnter the size of your deck, the board width and the joist spacing, and get a complete shopping list from posts to screws.🌲Timber volume calculatorEnter the number of pieces, the cross section and the length, and get the volume, running metres, weight for transport and the total price.🧰Stud wall calculatorEnter the wall length and height, the stud spacing and any door or window openings, and get the timber, boards and screws you need.📐Plasterboard calculatorEnter the wall or ceiling size, choose the sheet size and the number of layers, and get the number of sheets and all the fixings and finishing materials.🧶Insulation calculatorEnter the area, the insulation thickness and the pack coverage, and see how many packs you need and how much the insulation improves the U-value.🧱Brick calculatorEnter the wall size, the openings and your brick format, and get the number of bricks and the mortar you need, including waste.🔩Rebar calculatorEnter the slab size, the bar diameter and the spacing, and get the number of bars, running metres and steel weight for ordering.📏Square check calculator (3-4-5)Enter the two sides of your rectangle and get the exact diagonal, a 3-4-5 triangle that fits, and how far the diagonals may differ before the corner is out of square.

All tools (64) →